www.tomyang.net

Thank you.

Doing just that.

Will keep you posted.

Best

After 10 min of idling the centre and first carbs start a mini misfire where they actually spit out drops of fuel A pfff happens and you can see some drops of fuel being thrown up from carb You can't stand behind the car after 5 mins of starting . Eyes water . Fuel rich Smell. The throttle screw is ...

Any suggestions?

A friend far far away needs help....

Thank you guys. You are truly magicians!

Followed the instructions and the timing magically
got set within 5 minutes.

She is still running fuel rich so now turning attention
to setting the carbs.

Any suggestions on how to solve this?

I am having a little problem in setting the timing. This is the timing procedure followed before starting the engine. First rotated the engine and took cylinder nr 1 to TDC - Top Dead Centre. As per this position set the right bank distributor rotor to face number 1 wire . The flywheel TD marking al...

Thank you!

I know i had asked this question the first time
we had opened the engine but I am unable to find
that post.

What model nr of NGK spark plugs should i order
for the engine?

Best

Thank You

A set of new stainless steel pistons, all seals and hand brake pads were found and have been ordered from

Powertrack Limited
+441753842680
Www.powertrackbrakes.co.uk

They carry all brake and clutch parts.

Best

Hi Tom.

Will follow your advice re breaking in the engine.

Could you point me to a supplier of these pistons?

Many thanks

The engine has started!

We keep it running for about an hour everyday to
Seat and seal everything properly.

In the meanwhile have started working on the
Brakes and the suspension.

Need suggestions on where to buy pistons and seals
for all 4 calipers?

Best

Thank you.

That's the information i needed.

Now that the resistor has arrived the plan
Is to start the engine, run it for some time
Before sending the harmonic balancer off to
the usa for a rebuild.

Best

Enclosed are two pictures of the pulley

Thank you Tom and Mark. That's exactly the information i needed. The resistor has been ordered and is on its way to India. Will report back once fitted and engine started. My next question is regarding the pulley There is some kind of rubber seal which appears cracked. Trying to upload a picture. Wo...