gte cancel cam

Moderators: 330GT, abrent

Post Reply
enio45
Posts: 732
Joined: Wed Jul 02, 2003 6:56 pm
Location: Gilbert, AZ

gte cancel cam

Post by enio45 »

Tom, nice work....

i have also seen where they shim the turn signal lever out slightly to smooth the cancel operation. The shim is on the first collar (smaller one) when u assemble the lever to the column. The end of the steering shaft more or less floats within the column it self except where the bearing is located (which is down another 6 inches or so)....so the ability to shim the switch in and out helps the contact points inside at the cancel cam due to the little bit of flex in the shaft.

Hope this description makes sense :-)
Ed Montini
330 GT 2+2 Series II - 8289
58 Ellena - 0855GT - orig drivetrain
Post Reply