Knock-offs & Tools

Ferrari Message Board Archive 10/00-8/02
wwwboard
Posts: 0
Joined: Sun Oct 26, 2008 2:56 pm

Knock-offs & Tools

Postby wwwboard » Fri Jun 21, 2002 9:43 am

Posted by Todd

A while back there was a discussion of knock-offs and tools for them. Since then I bought a tool made by Mike Kumor at Seaport Mold & Casting. It is basically a round tube with notches cast in it to fit over the ears of the knock-offs. The business end is coated with rubbery stuff to prevent damage to the knock-offs. He makes these at his foundry, so I am sure he would be willing to sell as many of them as those of you out there might want.

wwwboard
Posts: 0
Joined: Sun Oct 26, 2008 2:56 pm

Re: Knock-offs & Tools

Postby wwwboard » Fri Jun 21, 2002 10:14 am

Posted by yale

can we see a picture? do you then use a pipe for torque? Yale

wwwboard
Posts: 0
Joined: Sun Oct 26, 2008 2:56 pm

Re: Knock-offs & Tools

Postby wwwboard » Fri Jun 21, 2002 5:34 pm

Posted by Mike Adams



I use Mike Kumor's knockoff tool also.  It is a big help at not over/under tightening the spinners.  Just set the torquewrench to 350ftlbs.  Here is a pic.

It leaves no marks on my spinners.

wwwboard
Posts: 0
Joined: Sun Oct 26, 2008 2:56 pm

Re: Knock-offs & Tools

Postby wwwboard » Fri Jun 21, 2002 5:39 pm

Posted by Mike Adams

Oops...  I thought it would just post the link, not the whole image...    Anyway, it uses a 3/4 torquewrench.

Here is a link to the site.

Now... to get him to make me some 6X DCN manifolds for my 330 :)


Return to “Ferrari Message Board Archive 10/00-8/02”

Who is online

Users browsing this forum: No registered users and 1 guest