330 Imported to UK
-
- Posts: 58
- Joined: Mon Nov 01, 2004 4:21 pm
- Location: England
330 Imported to UK
Hi I am the new owner of GT 6159 that was advetised on E Bay a while back.Now imported to UK from USA.
Engine was rebuilt in 85',spoke to the engine builder.Only done 600 miles since and been stood still for last 15 years.
I changed the fluids set the timing cleaned the carbs and plugs got the electric fuel pump working,renewed some perished fuel hoses. put some redex oil petrol in it squirted it in the bores and carbs and fired it right up.oil pressure came up quickly and let it idle for a while engine sounds good. stopped it and checked for leaks,looked good so started again and let it run till it warmed up.
No brakes with very floppy pedal suspected stuck piston in master cylinder dismantled it and fitted new seals.Bled brakes checked wheels and went for a drive about 2 miles.
Car gets all its gears no knocks all lights work and stops ok dont know about overdrive as i dont know where the switch is.
It sounds loud some holes in the silencer and 2 rear resonators are corroded so off with both systems up to the headers.Fabricated 2 new lower silencer casings cut some sections of tube and welded them in, re rubbered the hanging brackets and re fit. tomorrow ill see if i can get 150 out of it.
only joking ill change the tyres first.
Engine was rebuilt in 85',spoke to the engine builder.Only done 600 miles since and been stood still for last 15 years.
I changed the fluids set the timing cleaned the carbs and plugs got the electric fuel pump working,renewed some perished fuel hoses. put some redex oil petrol in it squirted it in the bores and carbs and fired it right up.oil pressure came up quickly and let it idle for a while engine sounds good. stopped it and checked for leaks,looked good so started again and let it run till it warmed up.
No brakes with very floppy pedal suspected stuck piston in master cylinder dismantled it and fitted new seals.Bled brakes checked wheels and went for a drive about 2 miles.
Car gets all its gears no knocks all lights work and stops ok dont know about overdrive as i dont know where the switch is.
It sounds loud some holes in the silencer and 2 rear resonators are corroded so off with both systems up to the headers.Fabricated 2 new lower silencer casings cut some sections of tube and welded them in, re rubbered the hanging brackets and re fit. tomorrow ill see if i can get 150 out of it.
only joking ill change the tyres first.
-
- Posts: 58
- Joined: Mon Nov 01, 2004 4:21 pm
- Location: England
Thanks Tom that did it.
wipers work but no washers because the bag is missing.looked up some prices on internet.Holy cow.
Fitted one from a fiat 126 which fits on the inner wing really well next to radiator. orriginality not a problem as I wont be at pebble beach concourse this year.
Mechanical fuel pump not working so rebuilt using a kit from Talacrest.
wipers work but no washers because the bag is missing.looked up some prices on internet.Holy cow.
Fitted one from a fiat 126 which fits on the inner wing really well next to radiator. orriginality not a problem as I wont be at pebble beach concourse this year.
Mechanical fuel pump not working so rebuilt using a kit from Talacrest.
-
- Posts: 58
- Joined: Mon Nov 01, 2004 4:21 pm
- Location: England
Hi.
Passed my MOT,which is road worthyness in UK a couple off weeks back.Then sent off for my UK registration (title) which came last week.Got some ally number plates stamped up and fitted so im fully road legal now.Did 50 miles or so this weekend. O/Drive works well thanks for the advice.Noticed the clutch slipping on gear change.ajusted the linkages a bit, they seem free. still slips so the box may need to come out.
Passed my MOT,which is road worthyness in UK a couple off weeks back.Then sent off for my UK registration (title) which came last week.Got some ally number plates stamped up and fitted so im fully road legal now.Did 50 miles or so this weekend. O/Drive works well thanks for the advice.Noticed the clutch slipping on gear change.ajusted the linkages a bit, they seem free. still slips so the box may need to come out.
330 GT 6159
uk 330 mk 1 owner too
hi graham
owned my 330 some 2yrs now......if can help you in any way withthing that are bound to arise would be glad too
lee
bath uk
owned my 330 some 2yrs now......if can help you in any way withthing that are bound to arise would be glad too
lee
bath uk
1964 330GT mk1 # 6201 [RHD]
1998 maserati ghibli 2.0 L [RHD]
1998 maserati ghibli 2.0 L [RHD]
Hi Graham
Congrats on the MOT, a nice Christmas present. Where abouts in the UK are you. I am just outside of London near St Albans and we have regular Ferrari meetings with the Hertfordshire Area Group of the FOC. Not too many old cars but a few (365GTB/4, 365BBs, 246, 400s etc).
Congrats on the MOT, a nice Christmas present. Where abouts in the UK are you. I am just outside of London near St Albans and we have regular Ferrari meetings with the Hertfordshire Area Group of the FOC. Not too many old cars but a few (365GTB/4, 365BBs, 246, 400s etc).
Simon in the UK
1973 246GT Dino
1976 365 Boxer
1977 400 Auto
1973 246GT Dino
1976 365 Boxer
1977 400 Auto
-
- Posts: 58
- Joined: Mon Nov 01, 2004 4:21 pm
- Location: England
Thanks lee might need it.
Simon Im in Burnley Lancs.25 miles north of Manchester so a bit too far to come for a club meet.
Done over 200 miles in it now, still taking it easy.Developed a bit of a stumble while accelerating. Right hand dizzy wasnt advancing so stripped it.wasnt particularily stiff but seems fine now.Think ill do the same to the other one.used about 1/2 pint of oil so far.
Simon Im in Burnley Lancs.25 miles north of Manchester so a bit too far to come for a club meet.
Done over 200 miles in it now, still taking it easy.Developed a bit of a stumble while accelerating. Right hand dizzy wasnt advancing so stripped it.wasnt particularily stiff but seems fine now.Think ill do the same to the other one.used about 1/2 pint of oil so far.
330 GT 6159
-
- Posts: 58
- Joined: Mon Nov 01, 2004 4:21 pm
- Location: England
-
- Posts: 58
- Joined: Mon Nov 01, 2004 4:21 pm
- Location: England
-
- Posts: 58
- Joined: Mon Nov 01, 2004 4:21 pm
- Location: England
Dizzy advance siezed again
dizzy advance seized again but this time revealed all.first time it locked at 10' it was removed stripped cleaned re greased assembled and fitted and ran fine but I wasn't happy as I didn't really find anything untoward.it wasn't stiff or anything and it seemed free and clean.anyway I was out in it and felt the familiar lack of power with a stumbling and popping back.I knew what it was and checked again with the strobe.stuck at 10' again.so off with it and started to pull it apart.this time the mech advance part incorporating the lobes wouldn't turn on the shaft.I didn't have this problem last time.closer investigation revealed that a plunger in one of the bob weights had jammed.the plunger consists of a spring in a sleeve with a domed head pin through the middle.the domed head had a small worn flat on its head from contact with the body.this allows the end of the pin to move far enough out of the bob weight to become hitched on the shoulder of the counter bored hole.plunger is now solid and wont let the weights expand.I didn't find this the first time as the pin must have shaken loose and seemed to have a normal action.once found it was with some fiddling possible to recreate the problem on the bench.suitably modified reassembled and refitted works properly and now hopefully sorted.now done over 400 miles total and starting to use more revs.
330 GT 6159
-
- Posts: 58
- Joined: Mon Nov 01, 2004 4:21 pm
- Location: England
-
- Posts: 58
- Joined: Mon Nov 01, 2004 4:21 pm
- Location: England
Re: 330 Imported to UK
wow 5 years have passed so heres a summary.
2005 Drove to the FOC National Meet, Boughton House, Geddington, UK had lots of interest because of as found condition.
2006 Drove to Kirkby Lonsdale Motor Club concourse where I was given an award "Most Faithful Servant" which is just a bit of fun award given to most well used looking car.
2007 May Drove to Bolton Abbey car show. Drove to Southport northern show.
2008 Off the road but fired up and moved.
2009 Off the road but fired up and moved.
2010 Hopefully driving to the Silverstone classic end of July.
now covered 2494 miles
2005 Drove to the FOC National Meet, Boughton House, Geddington, UK had lots of interest because of as found condition.
2006 Drove to Kirkby Lonsdale Motor Club concourse where I was given an award "Most Faithful Servant" which is just a bit of fun award given to most well used looking car.
2007 May Drove to Bolton Abbey car show. Drove to Southport northern show.
2008 Off the road but fired up and moved.
2009 Off the road but fired up and moved.
2010 Hopefully driving to the Silverstone classic end of July.
now covered 2494 miles
330 GT 6159
-
- Posts: 58
- Joined: Mon Nov 01, 2004 4:21 pm
- Location: England
Re: 330 Imported to UK
Made it to silverstone classic a round trip of just over 400 miles, no problems.
330 GT 6159
Re: 330 Imported to UK
A couple of pictures from Silverstone.
- Attachments
-
- Silverstone20100723_02.jpg (45.45 KiB) Viewed 11552 times
-
- Silverstone20100723_01.jpg (42.63 KiB) Viewed 11552 times
Regards, Kerry
http://www.330gt.com 330 GT Registry
http://www.parrotbyte.com/kbc/ferrari 250 PF Coupe 1643GT, 330 GT 2+2 8755GT, 308 GTS 23605
http://www.330gt.com 330 GT Registry
http://www.parrotbyte.com/kbc/ferrari 250 PF Coupe 1643GT, 330 GT 2+2 8755GT, 308 GTS 23605