A different 330 tools question
-
- Posts: 699
- Joined: Mon Nov 04, 2002 7:22 am
A different 330 tools question
Can someone with a proper toll kit provide the dimensions of the pliars and the machinists hamer in the factory kit? Michael
-
- Posts: 9
- Joined: Wed Sep 04, 2002 5:29 am
- Location: Laguna Beach, CA & Las Vegas, NV
- Contact:
I remember the pliers being 180mm in my 330GT 2+2 kit. Same as my Daytona kit. The look ALLOT like these USAG pliers with the rubber handles pulled off.
http://64.66.16.224/pliers-usag.jpg
Here is a pic of the 365GTC toolkit from the carrbooks handbook. ( "The green book" )
http://64.66.16.224/365-tools.jpg
They look the same as my 330 pliers.
I will have to measure the 500g hammer when I get back to Las Vegas. next week.
http://64.66.16.224/pliers-usag.jpg
Here is a pic of the 365GTC toolkit from the carrbooks handbook. ( "The green book" )
http://64.66.16.224/365-tools.jpg
They look the same as my 330 pliers.
I will have to measure the 500g hammer when I get back to Las Vegas. next week.
-
- Posts: 699
- Joined: Mon Nov 04, 2002 7:22 am
The pliers are approximately 7 3/4" long. Here's a picture of an original pair:
For more pictures of both original and reproduction tools, see:
http://www.parrotbyte.com/330GTRegistry/
Click on Resources and then Toolkit Information.
For more pictures of both original and reproduction tools, see:
http://www.parrotbyte.com/330GTRegistry/
Click on Resources and then Toolkit Information.