REMOVING LUSSO TURN SIGNAL STALK

[Steve Meltzer]

I have not yet started on this project, but before I do, can you remove the turn signal switch without removing the steering wheel? Any other tricks I need to be aware of?
thanks Steve

[John Vardanian]

Steve, See the pigtail in the pictures. First disconnect the four wires of this pigtail from the junction block which is just to the left of the heater box. Then unscrew the small chrome ring around the stalk, and then the large chrome ring that retains the domed bezel. The dome falls out and now you can pull out the switch along with the pigtail. The pigtail goes through a hole in the underside of the aluminum casting. Be careful not to lose the pieces. To reinstall, thread a wire in through the hole in the casting and out the opening of the stalk, then tape the wire to the tip of the pigtail so you can fish the pigtail back through that hole. Hope this helps. Feel free to call me if you have questions.

[Steve Meltzer]

John, THANX SO MUCH!! steve

[Steve Meltzer]

John, Thanks again for helping me with this. The stalk is on its way to ODD parts for repair. Much appreciated.! s

[John Vardanian]

Anytime Steve. I've had a handshake with every single part of the Lusso, as you might guess. The two white wires need to be marked, hopefully you did that. Otherwise you will crisscross the left/right signals.